Home
/
Research Reports
SOURCED INVESTIGATIONS & FIELD REPORTS
Robotics Research & Practical Limitation Reports
Primary-source investigations examining the delta between nominal manufacturer datasheets and real-world deployment telemetry, active sensor loads, and environmental constraints.
Source-based technical explainer
Published: 2026-10-08 | Verified: 2026-10-16
How to interpret published battery-runtime figures for quadruped robots and what to measure before planning an inspection or research mission.
Quick rule or relationship: estimated mission time = usable battery energy ÷ average power draw; use measured values for the actual configuration
Manufacturers publish runtime figures under stated or unspecified test conditions; those numbers may not predict a loaded field mission. Payload, gait, terrain, temperature, stops and onboard equipment can change energy use. The Spot and Go2 runtime figures are not directly comparable because test conditions and configurations differ.
Agricultural robotics explainer
Published: 2026-10-13 | Verified: 2026-10-16
A grounded introduction to spray payload, droplet drift and operating conditions for agricultural drones, using the manufacturer's T50 specifications.
Quick rule or relationship: downwind drift distance ≈ wind speed × time droplets remain airborne; actual drift depends on droplet size and conditions
DJI lists a 40 kg spraying payload and a separate 50 kg spreading payload for the Agras T50; they are not the same operating mode. Wind, droplet size, release height, evaporation and rotor flow affect where spray is deposited. A simple drift estimate is only a starting point. Follow the pesticide label, local aviation rules and the manufacturer's operating instructions.
Robotics comparison guide
Published: 2026-10-14 | Verified: 2026-10-16
A practical framework for comparing legged robots and wheeled mobile robots without assuming one type is always more capable or efficient.
Quick rule or relationship: compare systems using the same task, payload, route, operating time and energy-measurement method
Wheeled robots often suit prepared indoor routes, while legged robots can be considered where steps or uneven terrain matter. Energy, speed and uptime comparisons are meaningful only when the task and test conditions are comparable. A robot's advertised demonstration does not establish that it can perform a complete production workflow reliably.
